Teejet Legacy 6000 Manual Manual de usuario descargar pdf (Pagina 43)

Chapter 2 - System Overview38

Table 2-18: Monitor Settings

Settings Description

Input Denesdigitalandanalogsensors.SensorinputsA-Daredigital(owmeterandslot

sensors) and Sensors E-F are analog (pressure). 4-20 mA sensors can only be used on

the Sensor Input E on Gen I CAN systems. Gen II systems can read 4-20 mA and -5V

sensors on Inputs E and F.

Sensor Name Labels a particular sensor or monitor. This information is not stored in the Channel and

is used for messaging to the user only.

Calibration # Thecalibrationnumberinunitsspecied(FlowmeterandRotationsensorsonly).This

numberistypicallyfoundonthesensor.Physicalcalibrationwillfurtherne-tunethis

number.

Table 2-19: Monitor Sub-Settings

Settings Description

Alarm Units Pressure psi

Flowmeter gal/min

Shaft rpm

Min. Alarm Minimum alarm limit.

Max. Alarm Maximum alarm limit.

Alarm Delay Duration an alarm condition exists before triggering an alarm.

Alarm Status Off - disabled

Low - sensor state goes low to trigger alarm. Contact the sensor or machine supplier

for this information.

High - sensor state goes high to trigger alarm. Contact the sensor or machine supplier

for this information.

Channel Setup Completion

ThenalpageintheChannelSetupprocess is the Finish page. From the Fin-

ishpage,theoperatorcanreviewandconrmallpreviously-selectedoptionsby

pressing the Review Settingssoftkey.Theoptionscanalsobesavedtoalefor

later use by pressing the Save to File softkey (refer to CHAPTER 2 - SAVING

CHANNEL SETUP for additional information).

Channel settings can be applied directly to the channel without saving them by se-

lecting the Send to Channel softkey. The Channel will use the changes made dur-

ing application. If a new application is needed and the channel favorite or settings

have not been saved, all prior settings will be lost. Saving the channel favorites

takes very little time and can save time in the future.

Review Settings

softkey (F2)

Send to Channel

softkey (F6)

Save to File

softkey (F7)

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 158 159

Sin comentarios

Teejet Legacy 6000 Manual Manual de usuario Pagina 43