Teejet Legacy 6000 Manual Manual de usuario descargar pdf (Pagina 119)

Chapter 5 - System Tools114

Channels

The status of each channel on the CAN Bus can be viewed under Device Manager

- Channels. Each channel is assigned a Serial Number and an ID Number. One of

the channels must be assigned as the base channel. The base channel will receive

the ground speed input if provided by other than a GPS receiver.

Figure 5-5: Channels Setup

Table 5-4: Channels Settings

Softkey Description

Module Reset. Resets all modules to factory default or each channel can be reset.

UpdateFlash.Updatesthemodule’sash.SoftwaremustbeloadedonthePCCard

for the module to be updated.

Information. Displays general module information, serial numbers, and software ver-

sion.

Channel Setup

When using a Dual Control Module (DCM), the operator has the ability to use two

channels on each DCM connected to the CAN Bus. Each channel must be turned

on (YES) and a unique ID number must be assigned if the channel will be used.

1. Highlight the desired channel in the center of the screen using the Arrow

keys and press the Enter button.

2. Turn the channel on (YES) and set an ID number. Typically channel one

will be set to ID 1.

Arrow keys

Enter button

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 158 159

Sin comentarios

Teejet Legacy 6000 Manual Manual de usuario Pagina 119