Teejet Legacy 6000 Manual Manual de usuario descargar pdf (Pagina 40)

Legacy 6000

98-05053 R2

input lines for sensors are established on the Sensor Settings page.

Secondary Sensor options include:

Flowmeter

•

Pressure Digital•

Pressure Analog•

Granular•

Shaft•

Injection•

To access the sub-settings, locate the two Sub-Settings softkeys on the right side

of the screen. Use the two softkeys to toggle between the screens. Refer to Table

2-16 for a description of the sub-settings. When the primary settings and param-

eters have been selected, press the Forward Arrow softkey to advance to the next

Channel Setup page.

Figure 2-29: Secondary Sensor/Sub-Settings

Table 2-16: Secondary Sensor Sub-Settings

Settings Description

Input Denesdigitalandanalogsensors.SensorinputsA-Daredigital(Flowmeterand

slot sensors) and sensors E-F are analog (pressure).

Sensor Name Used to label a particular sensor or monitor. This information is not stored in the

Channel and is used for messaging to the user only.

Dual Warning% Denesthemaximumacceptable%differencebetweentheprimaryandsecondary

sensor outputs before the operator is warned.

Dual Warning Delay Denesthetimethattheprimaryandsecondarysensoroutputscanexceedthe

dual warning % before initiating the alarm.

Forward Arrow

softkey (F6)

Initial-Settings

softkey (F9)

Sub-Settings

softkey (F10)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 158 159

Sin comentarios

Teejet Legacy 6000 Manual Manual de usuario Pagina 40