Teejet Matrix Pro 840G User Manual Manual de usuario descargar pdf (Pagina 58)

98-05238 R1 EN-US

HOME OVERVIEWSETUP POWERAPPENDIX FULL SCREEN INTRODUCTIONGUIDANCE

Enable/Disable Angle Sensor

Set the use of a steering angle sensor to enabled or disabled.

1. Press DOWN arrow to access the list of options.

2. Select:

►Enabled

►Disabled

If Angle Sensor is set to “Disabled”, all Angle Sensor capabilities and

setup functions will be disabled (options will be grayed out).

Figure 6-41: Enabled and Disabled Assisted/Auto Steering Options

Cong-> AutoSteer->Angle Sensor

Angle Sensor

Calibrate Sensor

Oset Adjustment

Disabled

Enabled

Disabled

Calibrate Sensor

Calibrate Sensor sets the turn rate when steering the vehicle

left and right.

NOTE: A GPS signal is required for this test.

RECOMMENDATION: Have a large area of clear space available to

perform test cycles. Vehicle speed must be between 1.0 mph

and 8.0 mph / 1.5 - 13.0 km/hr (0.4 - 3.6 m/s).

1. Select Calibrate Sensor .

2. Slowly move the vehicle in a slow forward motion so

the center two calibration boxes ll to 100%.

3. While still moving, slowly turn to the right or left until the

appropriate right or left calibration boxes are lled to 100%.

4. While still moving, slowly turn in the opposite direction until the

appropriate left or right calibration boxes are lled to 100%

5. “Calibration Successful” will appear when both left and right

calibrations have been completed.

Press Stop to cancel the calibration.

Figure 6-42: Calibrate Sensor