Teejet Matrix Pro 840G User Manual Manual de usuario Pagina 49
- Pagina / 127
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
42
www.teejet.com
HOMEOVERVIEW SETUP POWER APPENDIXFULL SCREENINTRODUCTION GUIDANCE
Enable/Disable Assisted/Auto Steering
Set assisted/auto steering to On or Off.
1. Press DOWN arrow to access the list of options.
2. Select:
►On
►Off
Figure 6-24: Enabled and Disabled Assisted/Auto Steering Options
Cong-> AutoSteer
Enabled
Valve Setup
Steering Settings
Valve Test
Valve Diagnostics
Angle SensorOptions
On
On
O
If Enabled is set to“Off”, all Assisted/Auto Steering capabilities and
setup functions will be disabled (options will be grayed out).
Figure 6-25: Assisted/Auto Steering Off
Cong-> AutoSteer
Enabled
Valve Setup
Steering Settings
Valve Test
Valve Diagnostics
Angle SensorOptions
O
Valve Setup
Valve Setup is used to congure Valve Type, Valve Frequency,
Minimum Duty Cycle Left, Minimum Duty Cycle Right and Maximum
Duty Cycle.
1. Select
Valve Setup .
2. Select from:
►Valve Type – used to select the type of steering valve
►Frequency
– used to select the valve frequency used to
drive the steering valve
►Minimum Duty Cycle Left and Right – used to set
the minimum amount of drive required to begin steering the
vehicle left or right
►Maximum Duty Cycle – used to select the maximum
speed that the wheels will steer from lock to lock
Figure 6-26: Valve Setup
Cong-> AutoSteer
Enabled
Valve Setup
Steering Settings
Valve Test
Valve Diagnostics
Angle SensorOptions
On
Cong-> AutoSteer->Valve Setup
Valve Type
Frequency
Min DC Left
Max DC
Min DC Right
175 Hz
20%
20%
50%
Standard/PWM
Valve Type
Valve type is used to set the type of steering valve.
NOTE: See section “Verify Operation of Hydraulics and Set the
Steering Control Rate” of your specific FieldPilot Installation
Manual for your specific valve type.
1. Press DOWN arrow to access the list of options.
2. Select:
►Standard/PWM
►Standard Voltage
►Reversed Voltage
►One-Wire PWM
►UniPilot
Figure 6-27: Valve Type
Cong-> AutoSteer->Valve Setup
Valve Type
Frequency
Min DC Left
Max DC
Min DC Right
175 Hz
20%
20%
50%
Standard/PWM
Standard/PWM
Standard Voltage
Reverse Voltage
One-Wire PWM
UniPilot
- UsER MANUAL 1
- Table of Contents 2
- CHAPTER 6 SYSTEM SETUP 32 3
- CHAPTER 7 GUIDANCE 78 5
- CHAPTER 1 SYSTEM OVERVIEW 8
- SYSTEM COMPONENTS 9
- Matrix Pro 570G Console 9
- Additional Information 9
- Matrix Pro 840G Console 10
- RealView Camera 10
- Optional Accessories 11
- 98-05238 R1 EN-US 12
- CONFIGURATIONS 13
- 45-10103 15
- DC: xx/xx 15
- Speed Cable 17
- CHAPTER 2 POWER 18
- Setup Screens 20
- Setup Option Information 21
- Drop Down Menu Selections 21
- Dist to Boom (ft) 22
- Conguration 23
- < 0.0 > 24
- Simple Mode 29
- Advanced Mode 29
- SIMPLE MODE 30
- 8.9 < 32
- ADVANCED MODE 33
- 12/14/10 3:52 AM 36
- Continue 36
- CHAPTER 6 SYSTEM SETUP 39
- Ant Height (ft) 41
- Antenna Height (ft) 43
- Guidance Width (ft) 46
- Section 1 Width (in) 46
- Delay On Time (s) 47
- Delay O Time (s) 47
- Valve Setup 49
- Valve Type 49
- Valve Frequency (Hz) 50
- Test Right 51
- Steering Settings 53
- Coarse Steering Adjustment 53
- Fine Steering Adjustment 53
- Deadband 54
- Lookahead 54
- Valve Test 54
- Valve Diagnostics 55
- 1. Select Angle Sensor 57
- Enable/Disable Angle Sensor 58
- Calibrate Sensor 58
- Offset Adjustment 59
- Field Level 61
- LED Spacing (ft) 63
- GPS Status 65
- GGA Requirements 65
- Four Channel VSM 67
- Eight Channel VSM 67
- DATA MANAGEMENT 68
- Manage Data 68
- Manage Data Unavailable 69
- Duplicate Job Data 69
- Transfer 70
- Transfer Unavailable 71
- USB Storage 71
- Internal Storage 72
- Delete Job Data 72
- Reports 73
- Simple Job Mode Options 74
- Advanced Job Mode Options 74
- ESRI Data 75
- PDF Report 75
- KML Data 75
- CONSOLE 77
- Color Scheme 78
- Brightness 78
- Screenshot 78
- Capture a Screenshot 79
- Touch Screen Calibration 79
- Cultural 80
- Time Zone 81
- Calculator 83
- Units Converter 83
- Set Units 84
- Select Value 84
- 0.0 mph 0 ac 85
- Navigation Screens Icons 86
- Status/Information Screens 89
- Assisted/Auto Steering Status 90
- BoomPilot Status 90
- 0.0 mph 0.00 ac 100
- -13 7.2 mph 101
- A+ Nudge Feature 102
- > 0.0 < 103
- Enter Name 104
- Circle Pivot Guidelines 106
- Last Pass Guidelines 108
- Turn Now 109
- 12.7 > 109
- APPLICATION BOUNDARY 110
- Save Delete 111
- RETURN TO POINT 112
- Single Section 114
- ZOOM IN/OUT 114
- Vehicle View 114
- Field View 115
- PAN MODE 116
- REALVIEW SPECIFIC OPTIONS 116
- Single Camera Selection 117
- Split Camera View 118
- RealView Setup Options 118
- Guidance Over Video 119
- Guidance Unavailable 119
- Horizon Line Adjustment 119
- Steering Angle Indicator 120
- APPENDIX A TIME ZONES 121
- Atlantic 122
- Australia 122
- 0.0 ft 123
- Data Management 124
- Console Settings 125
Relacionado con productos y manuales para Ordenadores Teejet Matrix Pro 840G User Manual
(9 paginas)
(9 paginas)
(9 paginas)
(9 paginas)
(9 paginas)
Ordenadores Teejet Matrix 430 Manual de usuario
(12 paginas)
(12 paginas)
Ordenadores Teejet UniPilot Manual de usuario
(20 paginas)
(20 paginas)
Ordenadores Teejet Fieldware Link Manual de usuario
(36 paginas)
(36 paginas)
Ordenadores Teejet RX510 Manual de usuario
(3 paginas)
(3 paginas)
Ordenadores Teejet Fieldware Tool Manual de usuario
(48 paginas)
(48 paginas)
Ordenadores Teejet RMS Office Manual de usuario
(120 paginas)
(120 paginas)
Ordenadores Teejet RX370p Manual de usuario
(24 paginas)
(24 paginas)
Ordenadores Teejet RX375P Receiver Manual de usuario
(16 paginas)
(16 paginas)
Ordenadores Teejet RX 400p Manual de usuario
(151 paginas)
(151 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales