
20
www.teejet.com
HOMEOVERVIEW SETUP POWER APPENDIXFULL SCREENINTRODUCTION GUIDANCE
Implement Setup
When a SmartCable or Section Driver Module (SDM) is not present
only a single boom setup is available. Congurations for Overlap,
Delay On and Delay Off will not be available, and Number of
Sections will be set to one.
1. Press CONFIGURATION side tab .
2. Press
Implement .
3. Select from:
►Number of Boom Sections
#
– establishes the number of
boom sections
►Guidance Width – establishes the width between
guidelines
►Spray Width – establishes the width of each boom
section for a total spray width
►Overlap
– determines the amount of overlap allowed
►Delay On
– establishes the timing for the boom section
valves to switch on
►Delay Off – establishes the timing for the boom section
valves to switch off
4. Press RETURN arrow or CONFIGURATION side tab to
return to the main Conguration screen.
NOTE: Press or to switch between Implement setup screens.
Figure 3-15: Implement Setup Options
Conguration
Vehicle
Implement
AutoSteer
Tilt
Lightbar
GPS
Video
Cong->Implement
Num Sections
Spray Width
Guidance Width
60.00 ft
144.00 ft
15
Cong->Implement (2)
Overlap
Delay O
Delay On
1.00 s
1.00 s
50%
Comentarios a estos manuales