
104
www.teejet.com
HOMEOVERVIEW SETUP POWER APPENDIXFULL SCREENINTRODUCTION GUIDANCE
Figure 7-55: Save Boundary
Area bounded = 64.45 ac
Would you like to save the marked
boundary?
Save Delete
Use CANCEL BOUNDARY icon to cancel the new eld boundary
process and revert to the previous boundary (when established).
To establish one or more interior boundaries, follow the same steps
as the initial boundary.
Figure 7-56: Add Interior Boundary
While creating an external or initial boundary, the boundary line
will be to the exterior of the outer most active boom section. While
creating an interior or additional boundary, the boundary line will be
to the interior of the inner most active boom section.
Use DELETE BOUNDARY icon to delete all eld boundaries for
the current job.
Figure 7-57: Finish Boundary – Travel to starting point
5.48 ac 7.2 mph
Mark A
In correspondence to your current location, the
IN BOUNDARY icon or OUT BOUNDARY icon
is displayed on the Status Bar once the boundary is established.
Figure 7-58: Finish Boundary – Travel to starting point
5.48 ac 7.2 mph
Mark A
Comentarios a estos manuales