Teejet Fieldware Tool Manual de usuario descargar pdf (Pagina 33)

Fieldware

Tools

98-05048 R3

Step 5: Converting The File

Before converting the le, we should discuss the “Remove Layer From Map” check box located in the Source

group and the “Add Layer To Map” check box located in the Destination group. These settings determine what

happens to the source and destination les after the conversion has completed and the Convert dialog is removed

from the screen. The “Remove Layer From Map” check box species whether the source le (the current layer)

should be removed from the Map Manager map. The “Add Layer To Map” check box species whether the

destination le should be added to the Map Manager Map. If both boxes are checked, as in (Figure 36), the

source le is replaced by the destination le as Map Manager’s current layer.

You are now ready to press the Convert button and set the data transfer in motion. Once the button is pressed,

the Info bar begins displaying status information. If a problem is encountered, an error message is presented. If no

error occurs, the Convert dialog is removed from the screen and the Map Manager map is updated. (Figure

37) shows: (a) Spring 99-DAP.arm was converted to Spring 99-DAP.shp; (b) Spring 99-DAP.arm was removed

from the Map Manager map; (c) Spring 99-DAP.shp was added to the Map Manager map.

Figure 37: The Converted Spring 99-DAP.SHP Map

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

Sin comentarios

Teejet Fieldware Tool Manual de usuario Pagina 33