Teejet Fieldware Tool Manual de usuario descargar pdf (Pagina 25)

Fieldware

Tools

98-05048 R3

Running the Product Wizard

Select the type of application you are doing

(Figure 23). Press the Green forward to move to the

next wizard page.

Figure 23: Product Wizard Application Type

Next select the number of products used in the

application (Figure 24).

Figure 24: Product Wizard Number of Products

Select the Product Name (Figure 25). This is the list of

products found in the Product Prole. You can press

the NEW button to go directly to the Prole Builder.

From there you can add or edit a product.

Figure 25: Product Wizard Product Name

Once the product name has been selected, press the

Green arrow and select the Product Unit (Figure 26).

Figure 26: Product Wizard Product Unit

Next enter the Product Application Rate, Total Amount

of product applied, or both (Figure 27)

Figure 27: Product Wizard Application Rate

If you have selected more than one product, the

Product Wizard cycles back through Product Name,

Unit, and Application Rate until all products are

identied. After all product information is entered,

the next Wizard page is based on the Application

Type selected in the rst Wizard page (Figure 23).

In this example a Liquid (Wet) product was selected.

Therefore the next Wizard page is Water Unit (Figure

28). If a dry application type was selected the water

(carrier) Wizard pages would not appear.

Figure 28: Product Wizard Water Unit

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Sin comentarios

Teejet Fieldware Tool Manual de usuario Pagina 25