Teejet Tilt Compensation Module Guide_Legacy 6000 Manual de usuario descargar pdf

Tilt Compensation Module for Legacy 6000

TILT

COMPENSATION

MODULE

Bulletin 98-01149 R1

Page 1 of 2

Tilt Sensor Operation

The Legacy 6000 must be loaded with Fieldware software, version 3.10 or higher to be compatible with

the Tilt Sensor. When operating the Tilt Sensor the position data coming from the GPS receiver will be

compensated for vehicle tilt errors and then corrected information will be sent to the console.

When the vehicle experiences a sideways tilt, any guidance information is affected: For example, if the

GPS sensor is 12 feet (3.65m) above the ground, a 10-degree tilt gives a 2-foot (0.61m) positioning

error.

Tilt Sensor Functions

There are three LEDs visible on the Tilt Sensor which indicate the following:

• Blue - Blinks two times per second when the unit is powered and

running

• Green - Steady ON when tilt correction is enabled, OFF otherwise

• Yellow - Blinks one time per second when valid GPS location data

is being received (NMEA-0183 GGA)

Tilt Sensor Mounting Recommendations

1. Mount as close to the center of the vehicle side to side as possible.

2. Mount sensor on a parallel plain to the GPS antenna so both the antenna and the

sensor tilt the same degree.

3. Mount so the sensor is level and connector is pointing upward.

4. Sensor should be rigidly mounted to minimize vibration, because vibration will degrade

the ability to sense tilt.

5. Mid-Tech recommends using nuts and bolts or self tapping screws through the two

mounting holes on each end of the sensor.

6. The arrow on sensor decal must point toward the front of the vehicle.

7. Do NOT mount near extreme temperatures, upside down, or on its side.

Figure 1: Tilt Sensor Example

1 2

Legacy 6000 Settings 2

Indice de contenidos

Pagina 1

Tilt Compensation Module for Legacy 6000 TILT COMPENSATION MODULE Bulletin 98-01149 R1Page 1 of 2Tilt Sensor Operation The Legacy 6000 must be loade

Pagina 2 - Legacy 6000 Settings

Page 2 of 2Legacy 6000 Settings Once the Tilt Sensor is properly installed and connected to the Legacy 6000, two initial setup steps must be performed

Comentarios a estos manuales

Sin comentarios

Teejet Tilt Compensation Module Guide_Legacy 6000 Manual de usuario

Busca en linea o descarga Manual de usuario para Ordenadores Teejet Tilt Compensation Module Guide_Legacy 6000. TeeJet Tilt Compensation Module Guide_Legacy 6000 User Manual [en] [de] Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Ordenadores Teejet Tilt Compensation Module Guide_Legacy 6000