Teejet SENTRY 6510 Manual de usuario descargar pdf (Pagina 9)

990-630-EN R0

Sentry 6510 Capacity Monitor

Fitting the walker pads

Mount the two walker pads at the rear of the two outside straw walkers.

NOTE: Account for any reinforcements and walker extensions when positioning the walker pads.

1. Stick the supplied adhesive templates on the underside of the walkers with the arrow pointing to the rear of the walkers.

2. Drill the holes as shown on the templates.

Figure 5: Walker pad placement

Connecting the walker pad cables

The straw walker cable must contain a loop between the walker and the combine harvester body. The loop must be large enough to “capture”

the circular movement of the straw walkers without stressing the cable.

Figure 6: Walker pad cable loop

1. Attach the cable to the underside of the straw walker approximately 20 cm from the point at which the cable comes through the walker.

Attach the fastener carefully to preserve cable life.

Figure 7: Walker pad cable attachment

20 cm

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Sin comentarios

Teejet SENTRY 6510 Manual de usuario Pagina 9