Teejet SENTRY 6510 Manual de usuario Pagina 1

SENTRY 6510 CAPACITY MONITOR OPERATORS MANUAL & FITTING INSTRUCTIONSFirmware version 1.10

8www.teejet.comSentry 6510 Capacity Monitor2. Turn the straw walker to its lowest position and mark the side of the combine harvester (position A in

9990-630-EN R0Sentry 6510 Capacity MonitorOn some combine harvesters, it may not be possible to t the sensor in the recommended position due to place

10www.teejet.comSentry 6510 Capacity MonitorFigure 14: Bung and spacer placement7. Tighten the nuts so that the rubber swells slightly. NOTE: The bo

11990-630-EN R0Sentry 6510 Capacity MonitorOPERATIONUser interfaceFigure 17: User interface buttonsThe LEDs on each bar graph indicate the current rel

12www.teejet.comSentry 6510 Capacity MonitorCalculation of grain lossThis table indicates the number of lost seeds per metre of straw behind the combi

13990-630-EN R0Sentry 6510 Capacity MonitorSetting up the capacity monitorNot even the best capacity indicator can prevent grain from being lost. The

14www.teejet.comSentry 6510 Capacity MonitorDisplay indicationsA correctly adjusted monitor will indicate with the LEDs both the relative grain loss a

15990-630-EN R0Sentry 6510 Capacity MonitorStorage of valuesWhen + or - is pressed, the gain for both graphs are saved to the monitor. When the monito

SENTRY 6510 CAPACITY MONITOROPERATORS MANUAL & FITTING INSTRUCTIONSwww.teejet.com990-630-EN-A4 R0 English © TeeJet Technologies 2014

Copyrights© 2014 TeeJet Technologies. All rights reserved. No part of this document or the computer programmes described in it may be reproduced, copi

1990-630-EN R0Sentry 6510 Capacity MonitorTable of contentsINSTALLATION 2General overview ...

2www.teejet.comSentry 6510 Capacity MonitorINSTALLATIONGeneral overviewFigure 1: System diagram011108 0906, 0704 05100302

3990-630-EN R0Sentry 6510 Capacity MonitorItem Part number Description01 902-630 TeeJet Sentry 6510 Capacity Monitor02 198-716 Main cable03 907-012 St

4www.teejet.comSentry 6510 Capacity MonitorElectrical connectionsFigure 2: Close-up of electrical wiring0V14352+12V

5990-630-EN R0Sentry 6510 Capacity MonitorFitting the monitorPlace the monitor inside the driver’s cab in a position where it is easy for the operator

6www.teejet.comSentry 6510 Capacity MonitorMounting the wheel sensorMount the wheel sensor to the frame on the inside one of the steering wheels. Moun

7990-630-EN R0Sentry 6510 Capacity MonitorFitting the walker padsMount the two walker pads at the rear of the two outside straw walkers. NOTE: Accoun