Teejet LH 3000 Manual de usuario descargar pdf (Pagina 21)

LH 3000

OPERATING MANUAL

AGRO 21

CLEAR

The “clear” key is used for deleting any encoding and works almost like the c-key

of a pocket calculator. Used for deleting encode of faulty figures.

Besides the key is used for zeroing of total counters (flow + area).

EXAMPLE: Zeroing of “area”:

1. Press and simultaneously until the display is blank.

2. The area counter is now zeroed.

NB! The “CLEAR” key and the “MEMO” key are also used together for deleting

the memory. First press "MEMO" and then "CLEAR" and keep them

pressed simultaneously until the display shows "CLEAR".

Print of stores memory is started by pressing the "PRINT"-key.

EXAMPLE:

1. Connect printer

2. Press . The display will show "PRINT" and the last stored

card will be printed.

Are all job cards required printed do as follows:

3. Press for 3 seconds. The display will show "ALL" and all stored

cards will be printed.

NOTE: If print of all cards has been started the printer cannot be stopped until the

memory is empty.

Select of printer type is done in ENCODE point 14.

SYSTEM

The "SYSTEM" key is the key for "ENCODE". Only if programmed data, say

working width, should be changed, operation of this function will be needed. See

also page 8.

1 2 ... 16 17 18 19 20 21 22 23 24

Sin comentarios

Teejet LH 3000 Manual de usuario Pagina 21