Teejet Legacy 6000 CAN Guide Manual de usuario descargar pdf (Pagina 73)

Fieldware for the Legacy 6000

Software Version 2.11

Chapter 3 - Real-time Setup 3-3

Operation Overview

Step Description

Job: When the ARM Bullseye button is pressed, the Job page appears. Select

or create the desired job. A PC Card must be inserted in the console to store a

job. Press the forward key to continue to the ARM Launcher page.

System Calibration: If the delivery system (PCMs) has not been calibrated it

will be necessary to do this prior to starting product application. Distance cali-

bration can also be accomplished here. If the system is calibrated, skip this

step.

Job Report: If an application report will be generated when the job is complete,

it will be necessary to run Job Report to enter Weather, Crop, Field and Soils

information.

ARM Setup: This is where all files to be generated for the current job are auto-

matically named. There are two ARM settings: Auto Hold and System Delay.

When these settings are selected, they may not need to change. If the auto-

named files are satisfactory, skip ARM setup.

Product Setup: Allows the assigning of a products name, density and starting

quantity to a PCM. If using a prescription map, the product name can be auto-

matically extracted from the prescription file. Five preset application rates (A-E)

can also be defined.

When the above steps are accomplished and the console is properly setup,

begin product application by pressing the ARM Bullseye. (See “Chapter 4 -

Real-time Operation” on page 4-1.).

Table 3-1: Start Product Application Process

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 193 194

Sin comentarios

Teejet Legacy 6000 CAN Guide Manual de usuario Pagina 73