Teejet Legacy 6000 CAN Guide Manual de usuario descargar pdf (Pagina 138)

4-24 Chapter 4 - Real-time Operation

Real-time Guidance Operation

Fieldware for the Legacy 6000

Software Version 2.11

Circle Pivot Example

Marking Point A

In this example the operator wants to apply product to a portion of a field that has a center pivot on

it. The operator drives around this portion creating a headland. While driving parallel to an existing

wheel track the operator marks the initial A point. Figure 4-28 shows the operator beginning to

drive the along the center pivot perimeter. The operator has not pressed the Mark A button yet and

is notified on the lightbar to do so. Figure 4-29 shows the vehicle beginning to drive along the

existing wheel track and marking point A. In this example the operator has elected to drive a single

headland pass. This is not necessary, the operator could have driven along the wheel track and

marked points A and B and then started driving back and forth moving towards or away from the

center of the pivot.

Marking Point B

When point A is marked, the operator should drive along the pivot circle until they feel they have

described the circle as well as possible. The Mark A button has changed to Mark B button, (Figure

4-30). Fieldware does not allow the user to mark point B within 12 seconds of marking point A.

After 12 seconds, the Mark B button becomes active and the operator can mark point B anytime.

Figure 4-29: Marking Point A in Circle Pivot Pattern

Figure 4-30: Operating in Circle Pivot Pattern

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 193 194

Sin comentarios

Teejet Legacy 6000 CAN Guide Manual de usuario Pagina 138