Teejet TASC-6100 Manual de usuario descargar pdf (Pagina 27)

2-11

98-05018

CE & StandardVersion

TASC 6100

Setup

& Cal.

Low Product Alarm

The Low Product Alarm alerts the operator when the

Product Vol., displayed on the console, reads 10% of the

Full Load Capacity. The console beeps for three seconds

and displays the message "LO” - ”PROD". Console

control functions are not affected by this alarm. To

disable the alarm, do not recall the Full Load Capacity.

RESETTING ACCUMULATORS

se the following method to reset the Area,

Distance, and Total Applied accumulators to

zero:

A. Set the Console to the following switch settings:

1. Power ON

2. Mode Selector OPERATE

3. Display Selector Area / Total

Applied /Distance

B. Hold the INC./DEC. Switch to DEC. until the display

reads zero (Approximately 3 sec.)

NOTE: There is also an Area/SET-UP accumulator.

OPERATING UNDER EXTERNAL RATE COMMANDS

hen the TASC 6100 console is operating under

external rate commands, it must be connected

to the computer running the field mapping

program through a Mid-Tech Data Link. Minimum and

maximum anticipated rates must be programmed into the

Standard Rate and Alt.-Rate positions of the Rate switch

respectively and the Rate switch must be placed in the

Alt.-Rate position. The instructions, received with the

Data Link, explains in more detail how to set up the

TASC 6100 and Data Link.

DISPLAY SELECTOR

Speed

Area Impl. Width

Distance

Test

Speed

PSI/Prime

Total Applied

Application Rate

OFF SET- UP DEC.

OPERATE INC.

Scan

Product Vol.

Fan RPM

BOOMS

123456789

% Rate

A-1

A-2

A-3

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 85 86

Comentarios a estos manuales

Sin comentarios

Teejet TASC-6100 Manual de usuario Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Ordenadores Teejet TASC-6100