Teejet Matrix Pro 840G BoomPilot Setup Manual de usuario descargar pdf (Pagina 7)

98-05243-ENUS R2

Matrix

Pro

BOOMPILOT CONFIGURATION

The Matrix Pro is used to congure the vehicle and its implements.

To access Matrix Pro BoomPilot conguration options:

1. Press UNIT SETUP bottom tab .

2. Press CONFIGURATION side tab .

3. Select from:

►Vehicle – used to establish vehicle type, antenna height,

direction to boom and distance to boom.

►Implement – used to establish number of boom sections,

guidance width, spray width, overlap percentage, implement

delay on time and implement delay off time.

Figure 1-9: Configuration Options

Conguration

Vehicle

Implement

AutoSteer

Tilt

Lightbar

GPS

Video

Cong-> Vehicle

12.50 ft

0.00 ft

Front Wheel

Backward

Vehicle Type

Ant Height

Dir to Boom

Dist to Boom

Cong->Implement

Num Sections

Spray Width

Guidance Width

75.00 ft

Cong->Implement (2)

Overlap

Delay O

Delay On

1.00 s

50%

Vehicle Setup

Vehicle Setup is used to congure Vehicle Type, Antenna Height,

Direction to Boom and Distance to Boom.

1. Press CONFIGURATION side tab .

2. Press Vehicle .

3. Select from:

►Vehicle Type – used to select the type of vehicle steering that

most closely represents your vehicle

►Antenna Height – used to enter the height of the antenna

from the ground

►Direction to Boom – used to select whether the boom is

located behind or in front of the GPS antenna

►Distance to Boom – used to enter the distance from the GPS

antenna to the boom

4. Press RETURN arrow or CONFIGURATION side tab to

return to the main Conguration screen.

NOTE: All settings under Vehicle Setup are required for autosteer and

tilt sensor operation, as well as proper BoomPilot operation.

Figure 1-10: Vehicle Setup Options