Teejet IC18 NH3 JOB COMPUTER Manual de usuario descargar pdf (Pagina 31)

98-05230 R0 US

ISOBUS Job Computer : IC18 NH3

OVERVIEWSETUPAPPENDIX GETTING STARTEDOPERATION

Operation

Figure 3-15: Operation

Figure 3-16: Step % Increase/Decrease

Cnt 5

5.0

50.0

28.3

0.0

470 lbN 1.14 ac

+ 5%

1311

lb/mi/ac

lb/ac

mph

lb/ac

Operation establishes Application Rate Step, Speed

Source and Simulated Speed.

Application Rate Step

Application Rate Step is the percent of increase/decrease

“boost” of the active application rate at which the product

is being applied.

• To select the Application Rate Step, use the number

pad or slide bar.

Speed Source

Speed Source selects whether to base the machine’s

speed on input from the CAN, an Implement or a

Simulated source. Selecting “Implement” will allow for

the conguration of pulses per 300 feet / 100 meters.

Selecting “Simulated” will allow for simulated speed to be

entered using the “Edit Value” option. Selecting “CAN”

allows for speed being supplied by the ISOBUS CAN

(usually from the TECU) to be used.

• To select the Speed Source, select an option

from the drop down menu or use the UP/DOWN

ARROWS to highlight the option.

NOTE: If “Implement” is selected, refer to the Calibrations

section for further instructions.

Simulated Speed

Simulated Speed establishes a speed to be used when

using the Simulated Speed source.

• To select the Simulated Speed, use the number pad or slide bar.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 62 63

Comentarios a estos manuales

Sin comentarios

Teejet IC18 NH3 JOB COMPUTER Manual de usuario Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Ordenadores Teejet IC18 NH3 JOB COMPUTER