Teejet CenterLine v1.10 Manual de usuario descargar pdf (Pagina 37)

CenterLine

Software Version 1.10

CenterLine 33

CenterLine Real-Time Operation

Starting Real-time Operation

This section assumes that the setup section (See “CenterLine Setup” on page 13) has been read

and the CenterLine lightbar properly set up.

Start real-time operation by pressing Enter when <START> is displayed in the text window. The

<START> menu item is at the highest menu level. <START> can be easily reached from most

menu levels by scrolling to <TO START> and pressing Enter. This jumps to the <START> location

from anywhere in the menu structure (See Figure 32).

Figure 34 is a flow diagram of the CenterLine real-time operation and menu.

New? Resume?

When Enter has been pressed at the <START> location, a prompt to start a new field or resume

working in the current field appears. During real-time operation, CenterLine stores the vehicle’s

trajectory data. This allows the operator to stop working in a field before finished and return at a

later time, continuing where they left off. Only the current field is stored.

Use Up or Down to scroll between the <NEW?> and <RESUME?> menu items. Selecting

<NEW?> clears the current field trajectory data and starts a new field in memory. Selecting

<RESUME?> retains the current field trajectory data and allows the start of guidance using the

existing data.

Figure 34: Real-Time Operation Flow Diagram

STRAIGHT

HEADLAND

CURVED

PATTERN

Real-time Menu

NEW AB MARK A MARK B

NEW?

RESUME?SETUP

TOOLS

START

RIGHT

LEFT

AREA

APPLY OFF? APPLY ON?

EXIT

E-DIF WAIT

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 57 58

Sin comentarios

Teejet CenterLine v1.10 Manual de usuario Pagina 37