Teejet TASC-6500 Manual de usuario descargar pdf (Pagina 13)

2-3

98-05019

Rev- 1

TASC 6200/6500

CE & STANDARD VERSION

2.4 SETTING APPLICATION RATES

Each TASC channel can maintain a constant, preset application rate. To do this, the operator must enter the desired

application rates.

2.4.1 SETTING C CHANNEL APPLICATION RATE

A. Set the console switches to the following positions:

Power ON

Mode Selector SET-UP

Channel C Product Switch ON (CENTER)

Display Selector CARRIER, APPL. RATE

The display shows the current channel C application rate.

B. Use the INC/DEC switch to set the value displayed to the new desired rate.

C. Repeat with the Channel C Rate set to ALT-RATE. This establishes an alternate rate.

2.4.2 SETTING C CHANNEL PRODUCT DENSITY

TASC needs to know the product density in order to control the application rate of the product accurately. Product

density is entered in pounds per foot

(kilograms/tenths of meters

A. Set the console switches to the following positions:

Power ON

Mode Selector SET-UP

Channel C Product Switch ON

Display Selector CARRIER, VOL. APPLIED

The display shows the current channel C product density.

B. Use the INC/DEC switch to set the value displayed to the new desired rate.

C. NOTE: If channel C is being used as a liquid control channel, set the Product Density to 1.0

2.4.3 SETTING ALL OTHER APPLICATION RATES

A. Set the console switches to the following positions:

Power ON

Mode Selector SET-UP

Display Selector L & CHEMICALS, APPL. RATE

Channel 1,2,3 or L Product Switch ON (CENTER)

The display shows the current standard application rates for each channel.

NOTE: Whenever a channel is set to the split drive

option, all booms, to be used, must be turned "ON"

and have widths entered before the calibration num-

ber can be changed. If a boom position will not be used

it must be set to 0.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Sin comentarios

Teejet TASC-6500 Manual de usuario Pagina 13